JVC SP-UXM5 - Manual (Page 17)

– 14 –
Playing Back Tapes
• Use only type I normal tapes.
The use of tapes longer than 120 minutes is not
recommended, since characteristic deterioration may
occur and these tapes easily jam in the pinch roller and
the capstan.
Loading a Tape
1 Press
0 EJECT to open the
tape deck door.
2 Insert a recorded tape with the open side
down.
3 Close the tape deck door.
The TAPE indicator appears on the display.
Tape Playback
1 Press TAPE/REV.MODE.
2 Press
8/2 or 3/8 to select
the playback direction.
Playback starts.
“PLAY” appears on the display and
the playback direction indicator
moves to show the tape direction.
3 To stop playback, press
7.
To interrupt playback
Press the last selected
8/2 or 3/8.
“PAUSE” appears on the display.
• If you press the button opposite to the last selected
direction, playback starts in the reverse direction.
To resume playback, press
8/2 or 3/8 again.
Auto Reverse
Press TAPE/REV.MODE repeatedly
to select the desired playback mode.
: playback on one side of the tape only.
: both sides are played once.
:both sides are played repeatedly up to 10 times until you
press
7.
Rewind/Fast Forward
1 Press
4 or ¢ to rewind
or fast forward the tape.
“REW” or “FF” appears on the
display.
2 Press
7 to stop rewinding or
fast forwarding.
• The tape stops automatically at the end of the rewinding or
fast forwarding.
EJECT
TAPE
REV. MODE
DIRECTION PLAY/PAUSE
PRESET
STOP/CLEAR
DIRECTION PLAY/PAUSE
PRESET
SEARCH/TUNING
STOP/CLEAR
TAPE
REV. MODE
02_01_21_UXM5R_B_En.p65 5/22/02, 7:42 PM 14