Bar and chain combinations, Ec-declaration of conformity, Technical data – Jonsered 2141 User Manual
Page 35: Applies to europe only)
English –
35
TECHNICAL DATA
Bar and chain combinations
The following combinations are CE approved.
Bar
Chain
Length,
Pitch,
Max.
inches
inches
tip radius
13
0,325
10T
Jonsered S30
15
0,325
10T
Jonsered S30
16
0,325
10T
Jonsered S30
18
0,325
10T
Jonsered S30
13
0,325
10T
Jonsered S25
15
0,325
10T
Jonsered S25
16
0,325
10T
Jonsered S25
18
0,325
10T
Jonsered S25
1
5
L
Type
Inch
Inch/mm
Inch/mm
Degree
Degree
Degree
Inch/mm
Inch/cm: dl
S30
0,325"
0,050"/1,3
3/16" /4,8
85°
30°
10°
0,025"/0,65
13"/33:56 15"/38:64
16"/40:66 18"/45:72
S25
0,325"
0,058"/1,5
3/16" /4,8
85°
30°
10°
0,025"/0,65
13"/33:56 15"/38:64
16"/40:66 18"/45:72
A
–
2
EC-declaration of conformity
(Applies to Europe only)
Jonsered, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain saws Jonsered
2141 Turbo, 2145 Turbo, 2150 Turbo from 2002's serial numbers and onwards (the year is clearly stated in plain text on the type
plate with subsequent serial number), are in conformity with the requirements of the COUNCIL'S DIRECTIVES:
-
of June 22, 1998 ”relating to machinery” 98/37/EC, annex IIA.
-
of May 3, 1989 ”relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements.
-
of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
For information relating to noise emissions, see the chapter Technical data.
The following standards have been applied: EN292-2, CISPR 12:1997, EN608.
Notified body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has carried out EC type
examination in accordance with the machinery directive's (98/37/EC) article 8, point 2c. The certificates for EC type examination in
accordance with annex VI, have the number: 404/00/750 - 2141 Turbo, 404/00/750 - 2145 Turbo, 404/00/749 - 2150 Turbo.
In addition, SMP, Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has certified conformity with
annex V of the Council's Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC. The certificate
has the number: 01/161/021 - 2141 Turbo/2145 Turbo och 01/161/022 - 2150 Turbo.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna January 3, 2002
Bo Andréasson, Development manager