GE 24944 Universal Remote - Manual (Page 7)

7
Code Search
If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device ( TV, DVR, etc.) to be
controlled.
2. Press and hold the SETUP button until
the red indicator stays on, then release
the
SETUP button.
3. Press and quickly release the desired
device button ( TV, DVR, etc.). The red
indicator blinks off once.
4. Press the ON•OFF button repeatedly
(up to 300 times) until the device
to be controlled turns off. The red
indicator blinks off with each button
press.
Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you
want to store a VCR code under CABLE, first follow
the procedure for Direct Code Entry (previous page)
and press
CABLE in step 2 of Direct Code Entry, then
enter ANY VCR code in step 3 of Direct Code Entry.
Then follow the steps above for Code Search.
Note: Code Search starts from the currently stored
four digit number under that mode. Sometimes the
first code that “works” with your device may only
allow limited functionality (e.g. the MENU button
might not work). There may be a code that performs
more functions. Continue the code search process
until the best code is found.
5. Press and release ENTER to install the
code.