JVC CA-HXZ1 - Manual (Page 69)

– 28 –
English
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Troubleshooting
Cause
The button other than CANCEL/DEMO
is pressed to cancel the demonstration
temporarily.
Connections are incorrect or loose.
The built-in microprocessor may
malfunction due to external electrical
interference.
• The path between the remote control and
the remote sensor on the unit is blocked.
• The batteries are exhausted.
Vocal Masking is activated.
• Antennas are disconnected.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
The disc is scratched or dirty.
• The AC power cord is not plugged in.
• Trays are locked.
The disc is placed upside down.
Power supply from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette are
removed.
Action
Press CANCEL/DEMO on the unit.
(See page 8.)
Check all connections and make
corrections. (See pages 6 to 8.)
Unplug the AC power cord and then plug it
back in.
• Remove the obstruction.
• Replace the batteries.
Cancel the Vocal Masking. (See page 22.)
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
Clean or replace the disc. (See page 27.)
• Plug the AC power cord.
• Unlock the trays. (See page 17.)
Place the disc with the label side up.
Turn on the unit.
Cover the holes with adhesive tape.
(See page 19.)
Specifications
Amplifier section
Output Power (IEC 268-3)
SUBWOOFERS:
85 W per channel, min. RMS, both channels
driven into 6
Ω
at 63 Hz with no more than
0.9% total harmonic distortion.
MAIN SPEAKERS: 22 W per channel, min. RMS, both channels
driven into 6
Ω
at 1 kHz with no more than
0.9% total harmonic distortion.
Audio input sensitivity/Impedance
(Measured at 1 kHz, with tape recording signal 300 mV)
AUX: 390 mV/50 k
Ω
ΜΙΧ 1/2: 1.5
mV
/5
k
Ω
Digital output: CD OPTICAL DIGITAL OUTPUT
Signal wave length: 660 nm
Output level: –15 dBm to –12 dBm
Speakers/Impedance:
SUBWOOFERS: 6
Ω
– 16
Ω
MAIN SPEAKERS: 6
Ω
– 16
Ω
Tuner
FM tuning range: 87.50 MHz – 108.00 MHz
AM tuning range: At 9 kHz intervals: 531 kHz – 1 710 kHz
At 10 kHz intervals: 530 kHz – 1 710 kHz
CD player
CD capacity: 3 CDs
Dynamic range: 85 dB
Signal-to-noise ratio: 90 dB
Wow and flutter: Immeasurable
Cassette deck
Frequency response
Normal (type I): 50 Hz – 14 000 Hz
Wow and flutter: 0.15% (WRMS)
General
Power requirement: AC 110 V / AC 127 V / AC 220 V /
AC 230 V – AC 240 V
(adjustable with
the voltage selector), 50 Hz / 60 Hz
Power consumption: 160 W (in operation)
24 W (on standby with Ecology Mode off)
Less than 3.5 W (on standby with Ecology
Mode on)
Dimensions (approx.): 205 mm x 370 mm x 370 mm (W/H/D)
Mass (approx.):
10.0 kg
Supplied accessories
See page 6.
Design and specifications are subject to change without notice.
Symptom
Unable to cancel the demonstration.
No sound is heard.
Operations are disabled.
Unable to operate the unit from the
remote control.
Stereo effect is lost.
Hard to listen to broadcasts because of
noise.
The disc sound is discontinuous.
The disc tray does not open or close.
The disc does not play.
The cassette holders cannot be opened.
Impossible to record.
GENERAL
TUNER
CD
T
APE
REC
EN27-28.CA-HXZ1[UW]f.pm6 4/16/02, 5:43 PM 28