JVC XV-THS5 - Manual (Page 12)

Connections
9
Note that the illustration below is for TH-S5.
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
• When installing the satellite speakers on the wall;
• Be sure to have them installed on the wall by a qualified personnel.
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
• Care must be taken in selecting a location for speaker installation
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
Connecting the satellite (front, center, surround)
speakers
Center speaker
( TH-S5: SP-THS5C * 1
TH-S51: SP-THM303C * 2
)
• Connect the silver cords to the black (r) terminals.
• Connect the copper cords to the (q) terminals
referring to the table below:
Speaker cord (supplied)
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
( TH-S5: SP-PWS5
TH-S51: SP-PWS51 )
Front speakers
( TH-S5: SP-THS5F * 1
TH-S51: SP-THM303F * 2
)
Surround speakers
( TH-S5: SP-THS5S * 1
TH-S51: SP-THM303S * 2
)
4 m
10 m
4 m
*1 For TH-S5 *2 For TH-S51, the satellite speakers are equipped with their speaker cords attached
directly to their speaker unit instead of having speaker terminals on their cabinet.
Copper
Red
Black
Silver
Front/Center
speakers Surround
speakers
TH-S5-S51[B]-04Start.fm Page 9 Monday, February 2, 2004 2:20 PM