Ice maker use, Normal sounds, How your ice maker works – Jenn-Air W10136129C User Manual

Page 10: Using the controls

Advertising
background image

10

Normal Sounds

Your new ice maker may make sounds that are not familiar to
you. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces such as floors, walls and cabinets can make the sounds
seem louder than they actually are. The following describes the
kinds of sounds that might be new to you and what may be
making them.

You will hear a buzzing sound when the water valve opens to
fill the water reservoir for each cycle.

Rattling noises may come from the flow of the refrigerant or
the water line. Items stored on top of the ice maker can also
make noises.

The high-efficiency compressor may make a pulsating or high
pitched sound.

Water running over the evaporator plate may make a
splashing sound.

Water running from the evaporator plate to the water reservoir
may make a splashing sound.

As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your ice maker.

You may hear air being forced over the condenser by the
condenser fan.

During the harvest cycle, you may hear a “thud” when the ice
sheet slides from the evaporator onto the cutter grid.

When you first start the ice maker, you may hear water
running continuously. The ice maker is programmed to run a
rinse cycle before it begins to make ice.

ICE MAKER USE

How Your Ice Maker Works

When you first start your ice maker, the water pan will fill and the
system will rinse itself before starting to make ice. The rinsing
process takes about 5 minutes.

Under normal operating conditions, the ice maker will cycle at
preset temperatures. The ice level sensor located in the ice
storage bin will monitor the ice levels.

IMPORTANT:

If the water supply to the ice maker is turned off, be sure to
set the ice maker control to OFF.

The ice maker is designed to make clear ice from the majority
of water sources on a daily basis. If your results are
unsatisfactory, your water may need to be filtered or treated.

The Ice Making Process

1. Water is constantly circulated over a freezing plate. As the

water freezes into ice, the minerals in the water are rejected.
This produces a sheet of ice with a low mineral content.

2. When the desired thickness is reached, the ice sheet is

released and slides onto a cutter grid. The grid divides the
sheet into individual cubes.

3. The water containing the rejected minerals is drained after

each freezing cycle.

4. Fresh water enters the machine for the next ice making cycle.

5. Cubes fall into the storage bin. When the bin is full, the ice

maker shuts off automatically and restarts when more ice is
needed. The ice bin is not refrigerated, and some melting will
occur. The amount of melting varies with room temperature.

NOTE: As the room and water temperatures vary, so will the
amount of ice produced and stored. This means that higher
operating temperatures result in reduced ice production.

Using the Controls

1. To start the normal ice making cycle, press ON.

2. To stop ice maker operation, press and hold OFF.

NOTES:

Pressing the ON/OFF switch does not shut off power to
the ice maker.

Allow 24 hours to produce the first batch of ice. Discard
the first batch produced.

Control Lock

The control panel can be turned off for easy cleaning or to avoid
unintentional activation by children or small pets.

NOTE: The control lock feature does not shut off power to the ice
maker or to the ice maker bin light. It simply deactivates the
control panel.

1. To lock the control panel, press and hold the Control Lock

button until the indicator appears.

2. To unlock the control panel, press and hold the Control Lock

button until the indicator disappears.

Advertising