Jenn-Air W10136129C User Manual

Page 12

Advertising
background image

12

3. Pull the bottom forward and then pull down to remove the

lower access panel.

4. Remove dirt and lint from the condenser fins and the unit

compartment with a brush attachment on a vacuum cleaner.

5. Replace the lower access panel using the four screws.

6. Plug in ice maker or reconnect power.

Interior Components

1. Unplug ice maker or disconnect power.

2. Open the storage bin door and remove any ice that is in the

bin.

3. Remove the drain cap from the water pan and drain

thoroughly. Replace the drain cap securely on the water pan.
If the drain cap is loose, water will empty from the water pan,
and you will have either thin ice or no ice.

4. Remove the two screws that hold the cutter grid cover in

place and remove the cutter grid cover.

5. Unplug the wiring harness from the left side of the cutter grid.

6. Unplug the ice level sensor from the right side of the cutter

grid. Pull the ice level sensor down and forward away from
the cutter grid.

7. Remove the right-hand and left-hand screws. Lift the cutter

grid up and out.

NOTE: Make sure the plastic spacer from the right-hand side
of the cutter grid bracket stays with the cutter grid.

8. Remove the two thumb screws that hold the water pan in

place. Push down with one hand on the front of the pan while
pulling forward on the bottom back side.

9. Remove, clean and replace the ice scoop and ice scoop

holder.

After removing the ice scoop, remove the holder by
removing the two thumb screws.

Wash the ice scoop holder along with the other interior
components using the following instructions.

Replace the ice scoop holder by replacing the thumb
screws.

10. Wash the interior components (cutter grid, exterior of hoses,

and water pan) and the storage bin, door gasket, ice scoop,
and ice scoop holder with mild soap or detergent and warm
water. Rinse in clean water. Then clean the same parts with a
solution of 1 tbs (15 mL) of household bleach in 1 gal. (3.8 L)
warm water. Rinse again thoroughly in clean water.

NOTE: Do not remove hoses. Do not wash plastic parts in
dishwasher. They cannot withstand temperatures above
145°F (63°C).

11. Replace water pan by pushing back on the bottom with one

hand while pushing up and back on the top. Secure the water
pan by replacing both screws.

12. Check the following:

Drain cap from the water pan is securely in place. If the
drain cap is loose, water will empty from the water pan,
and you will have either thin ice or no ice.

Hose from water pan is inserted into storage bin drain
opening.

13. Slide the cutter grid back into place and secure it by

replacing the right-hand screw and plastic spacer. Then
tighten the left-hand screw. Reconnect the cutter grid
harness and the ice level sensor harness.

14. Replace the cutter grid cover and the two screws.

15. Plug in ice maker or reconnect power.

A. Cutter grid cover
B. Screws

A. Cutter grid harness
B. Screw

C. Cutter grid

D. Ice level sensor harness

E. Plastic spacer
F. Screw

A

B

A
B
C

D

E

F

A. Water pan
B. Water pan thumb screws

C. Drain cap

A. Thumb screw
B. Ice scoop holder

A
B

C

B

B

A

Advertising