Jwin JC-CD160 - Manual

Instruction Manual
CAR CD PLAYER ASP 12/45SEC
RECEIVER(AM/FM)
DETACHABLE FRONT PANEL
FUNCTION OF CONTROLS
-- 1 --
R
JC-CD160
DISP RPT RDM SCAN ALL DIR SONG
MUSIC MUTE LOUD MONO AF PTY EON
JAZZ
CLASSIC
LUD
LUD
SCN 3 RPT 4 RDM 5 6 MODE
BND MUT CLK
ST LOC LUD
LUD
1 A/PS 2 INT
L E S
H S U P
60 WATT/DIGITAL TUNING SYSTEM
C D / C D - R / C D - R W P L A Y E R
6 7
8
9
10
12
1
2
3
4 13 11 15
18
DISP RPT RDM SCAN ALL DIR SONG
MUSIC MUTE LOUD MONO AF PTY EON
JAZZ
CLASSIC
LUD
LUD
SCN 3 RPT 4 RDM 5 6 MODE
BND MUT CLK
ST LOC LUD
LUD
1 A/PS 2 INT
L E
S
H S U P
60 WATT/DIGITAL TUNING SYSTEM
C D / C D - R / C D - R W P L A Y E R
5 14 16
17 19
20 21 23
FUNCTIONS
CONTROL
1 POWER ON/OFF
Press the button to power up the unit
Press and hold for more than 1 second to turn off unit.
2,3. SEL (control mode select)/MENU KEY
Push to select the desired mode,VOL(volume),BAS(bass),TRE(treble)
BAL(balance),or FAD(fader).
This button normally functions as the volume control.Adjust the level
rotate(3)
clockwise after selecting the desired control mode.
Otherwise the mode will go back to the volume control mode.
Control Mode
Volume control
Bass control
Treble control
Balance control
Fader control
For less volume
For less bass
For less treble
To decrease the right speaker volume
To decrease the front speaker volume
For more volume
For more bass
For more treble
To increase the left speaker volume
To increase the rear speaker volume
MENU KEY
Hold the SEL key to choose the menu.
22
Turn clockwise: Turn counter clockwise:
1) menu1:
Rotate the SEL knob
AUDIO DSP FUNCTION
Press and hold longer than one second to activate the DSP feature. to select
DSP mode sound effect as shown in sequence below .User setting value of bass/treble in normal
mode is always memorized.In rock/classic/pops mode,bass/treble mode is skipped and level is
not changeable
FLAT----CLASSICS----POP M----ROCK M----DSP OFF.
Bass and Treble gain of each mode is as shown in below table.
Initial value of bass/treble in NORMAL mode is 0 dB.