JVC TH-SW8 - Manual (Page 19)

Connections
14
You can enjoy the sound of an analog component.
NOTE
• If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this system, the sound output
through this system may be distorted.
• When playing a video component such as a VCR;
• To listen to the sound, select “AUX” as the source to play.
(
A pg. 18)
• To see the picture, connect the video output jack of the component
to the video input jack of the TV directly, and select the correct
input mode on the TV.
You can enjoy the sound of a digital component.
* DBS = Direct Broadcasting Satellite
NOTE
When playing a video component such as a DBS tuner;
• To listen to the sound, select “AUX DIGITAL” as the source to play.
( A pg. 18)
• To see the picture, connect the video output jack of the component to
the video input jack of the TV directly, and select the correct input
mode on the TV.
Make sure that all other connections have been completed.
* To prevent noise over the radio reception, be sure to connect the
wireless receiver’s power cord to an AC outlet separately located
from the one the center unit and the powered subwoofer are
connected.
CAUTION
• Disconnect the power cord before cleaning or moving the system.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp and pull the plug so as not to damage the cord.
Connecting the powered
subwoofer
Connecting to an analog
component
Powered
subwoofer
System cord
(supplied)
Center unit
Align the 5 marks. Align the 5 marks.
AUX IN
RIGHT
LEFT
RCA pin plug cord
(not supplied)
Center unit
VCR
TV
Cassette recorder
To audio output
Connecting to a digital
component
Connecting the power
cord
DIGITAL
IN
OPTICAL
Digital optical cord
(not supplied)
To digital optical
output
DBS * tuner
MD recorder
Center unit
AC IN
Center unit Powered
subwoofer
Power cord
(supplied)
Power cord
Plug into AC outlets. *
Wireless
receiver unit
TH-SW9SW8[B]-04Start.fm Page 14 Thursday, April 22, 2004 9:38 AM