JVC GY-HM700U - Manual (Page 103)

99
You can enlarge and display only the characters of the status screen on the LCD monitor.
Memo :
● During enlarged display of the status on the LCD monitor screen, the video image remains displayed on the viewfinder.
Enlarged Status Display on
LCD Monitor
DF
FREE
A
B 123 min
min
OK
1280 x 720
60p HQ
CH1
CH2
STBY
100min
67.8min
STBY REVIEW STOP REC
DD
A
B
C
D
E F H G
I
J
Item Description
A Audio Level Meter Displays the audio levels of [CH-1] and [CH-2].
If the reference audio level (
A-20dBB or A-12dBB) is exceeded, this is displayed in yellow. The AOverB area is
displayed in red. A48kB is the sampling frequency.
Memo :
● When [Rec Mode] in the [Rec Mode] menu is set to AVariable FrameB, audio cannot be recorded and is
indicated by the mark.
B Framing Mode Displays the framing mode.
[DF]
: Drop frame
[NDF] : Non-drop frame
C Time Code Generator Displays the operation mode of the time code. (Display: [FREE], [RECR], [REGN]) ( A Page 46)
D Media Status Displays the SDHC card status in characters and symbols.
---- : No card found in the selected slot
STBY : Recording standby (recording pause)
REC : Recording
REVIEW : Clip Review ( A Page 52)
STBYP : Pre Rec recording standby ( A Page 54)
RECP : Pre Rec recording ( A Page 54)
STBYC : Clip Continuous recording standby
( A Page 55)
RECC : Clip Continuous recording ( A Page 55)
STBYC (displayed in red)
: Clip Continuous recording pause
( A Page 55)
STOP : Unable to record to the card in the slot
POFF : Power OFF
E Remaining Space on
Media Displays the remaining recording time on the SDHC card. The currently active slot is indicated with an enlarged
black card icon with white letters. A key mark appears when the write-protect switch of the SDHC card is set.
F OK Mark Appears as [OK] when the currently played clip is appended with an OK mark.
G Video Format Displays the video format that is set. ( A Page 36)
H Voltage/Battery
Power Displays the current status of the power supply in use.
Display Description
Currently powered by an AC adapter. The current voltage is shown on the right.
If the supplied voltage from the AC adapter is low, the voltage value will be displayed in
red as a warning.
Currently powered by a battery.
When the battery power runs out, the battery mark appears hollow, and
ARESB is displayed.
Memo :
● The display on the right can be set using [Battery Info] of [Status Display...] in the [LCD/
VF] menu. ( A Page 85)
I Operation of External
Device Displays the operating status of the connected external device.
For details, refer to the instruction manual of the corresponding external device.
J Time Code (TC)/
User’s Bit (UB) Displays the time code (hour:minute:second:frame) or user’s bit data.
12.3V
12.3V
200min
30%
RES
0 0 : 0 0 : 0 0 : 0 0
Colon (:) for non-drop frames
Dot (.) for drop frames