Getting started, Step 1 – the remote control, Quick setup – JVC AV-48P787 User Manual

Page 12: Key feature buttons, Basic operation

Advertising
background image

12

These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away. If you have questions, or for more detailed
information on any of these steps, please consult other sections of this manual.

Quick Setup

Getting Started

Before you can operate your remote control, you first
need to install the batteries (included).

Lift and pull the latch on the back of the remote control
to open. Insert two batteries (included) carefully noting
the “+” and “–” markings, placing the “–” end in the unit
first. Snap the cover back into place.

When you change the batteries, try to complete the
task within three minutes. If you take longer than
three minutes, the remote control codes for your
VCR, DVD, and/or cable box/satellite receiver may
have to be reset. See pages 24 - 27.

Step 1 – The Remote Control

Key Feature Buttons

The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through the
available channels. To move rapidly through the channels
using JVC’s Hyperscan feature, press and hold CH+ or
CH –. The channels will zip by at a rate of five channels per
second. The right and left buttons will turn the volume up or
down. These buttons are also marked with four arrows and
are used with JVC’s onscreen menu system. To use the
onscreen menus, press the M

ENU

button.

Basic Operation

Turn the television on and off by pressing the P

OWER

button at the top right

corner of the remote. If this is the first time you are turning on the TV, the
interactive plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if

you need to operate a cable box.

• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to

DVD to control a DVD player. Please see pages 24 to 27 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.

MUTING

MENU

OK

BACK

CH +

VOL

VOL

+

VCR/

DVD

CH –

POWER

TV CATV

V VCR

DVD

LCT2121-001A-A English.indd 12

LCT2121-001A-A English.indd 12

6/21/06 9:30:28 AM

6/21/06 9:30:28 AM

Advertising
This manual is related to the following products: