JVC KS-FX725R - Manual (Page 9)

9
ENGLISH
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If you
have not stored them yet, see “Storing stations in
memory” on pages 8 and 9.
1
Select the band (FM1 – 3, AM).
2
Select the number (1 – 6) for the preset
station you want.
Scanning broadcast stations
(only for KS-F525)
When you press SCAN while listening to the
radio, station scanning starts.
Each time a broadcast is tuned
in, scanning stops for about 5
seconds (tuned frequency
number flashes on the display),
and you can check what program
is now being broadcast.
If you want to listen to that program, press the
same button again to stop scanning.
2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
SCAN
AM
FM1 FM2 FM3
“P 1” flashes for a few seconds.
KS-FX725R
KS-F525
Press 4 to tune
in to stations of lower
frequencies.
Press ¢ to tune
in to stations of higher
frequencies.
FM1 FM2 FM3 AM
EN06-09KS-FX725R_F525[EE]f.pm5 7/12/01, 9:50 AM 9