Jet Tools 720HD - Manual (Page 8)

8
Assembly
Tools required for assembly
forklift or hoist with straps/slings
14mm wrench (provided)
4 and 6mm hex wrenches (provided)
1. Remove the four screws that secure the
Mortiser to the wood pallet, using a 14mm
wrench.
2. With a forklift or hoist, lift the machine off the
pallet and into its desired location.
3. The Mortiser should be located in a dry
area, on a sturdy, level floor, and with
sufficient lighting. Leave plenty of space
around the machine for operations and
routine maintenance work.
4. If desired, the Mortiser can be further
stabilized by securing it to the floor, using
lag screws through the four holes in the
base.
The mortiser should be
disconnected from the power source during
assembly procedures.
5. Unpainted areas of the machine have been
treated with a rust preventative. This should
be removed with a soft cloth and a mild
solvent. Do not use paint thinner, lacquer
thinner, gasoline or mineral spirits; these will
damage painted surfaces and plastic parts.
Do not use an abrasive pad.
Installing Handle
1. Use a 4mm hex wrench to remove the
screw, washer and spring from the shaft
(Figure 1).
2. Mount the hub of the handle onto the shaft
as shown. Make sure the hub slides all the
way onto the shaft.
3. Re-install spring, washer and screw. Tighten
screw.
Installing Wood Table
1. To install the wood table, first remove the
right hand screw at the right of the clamp
(Figure 2), with a 6mm hex wrench, and
loosen the left hand screw from beneath.
Pivot the clamp out of the way.
2. Mount the wood table with two flat head
screws as shown.
3. Re-position the clamp and install the screw.
Figure 1
Figure 2