0 power requirements, Us/canada j-230 2-pump model (60hz) – Jacuzzi LED SERIES J-230 User Manual

Page 13

Advertising
background image

page 

6.0 Power Requirements

Jacuzzi

®

spas are designed to provide optimum performance and flex-

ibility of use when connected to the maximum electrical service listed in
the tables below. If you prefer, your dealer can perform a minor circuit
board modification to allow your spa to accept an electrical service other
than the factory setting.

US / Canada J-230 2-Pump Model (60Hz)

240V/40A*

240V/50A**

240V/60A***

Voltage:

240 VAC

240 VAC

240 VAC

# of Wires:

3

3

3

Frequency:

60Hz

60Hz

60Hz

Current Draw:

26A

36A

45A

Circuit Breaker:

40A, 2-Pole

50A, 2-Pole

60A, 2-Pole

* In 40A configuration, the heater will not operate while either jets

pump is running in high speed. Note: pump 2 runs only in high speed.

** In 50A configuration, the heater will not operate while both jet pumps

are running in high speed. Note: pump 2 runs only in high speed.

This is the factory setting.

*** In 60A configuration, the heater will operate while both jet pumps are

running in high speed. Note: pump 2 runs only in high speed.

US/Canada J-210/J-220 1-Pump Convertible Model (60Hz)

120V/15A*

240V/30A*

240V/40A**

Voltage:

120 VAC

240 VAC

240 VAC

# of Wires:

3 (15A GFCI Cord

4

4

US only*)

Frequency:

60Hz

60Hz

60Hz

Current Draw:

12A

21A

30A

Circuit Breaker:

15A, 1-Pole

30A, 2-Pole

40A, 2-Pole

For 240 VAC Heater Operation: Move the red wire on the main terminal

strip (TB1) from position #1 to position #3. Make certain wires are con-

nected exactly as shown in Figure-D (page 12) before applying power.

Failure to do so will result in damage to the circuit board and/or related

components and void the manufacturer’s warranty.

*All Canadian spas must be hard wired (120 VAC or 240 VAC) per

CSA Canadian standards. (page 4).

* In 15A/30A configuration, the heater will not operate at the same

time as the high-speed jets pump. The factory setting is 120V/15A.

** In 40A configuration, remove the jumper JP1 #1-2 on the circuit

board to allow the heater to operate at the same time as the

high-speed jets pump (page 32).

Advertising
This manual is related to the following products: