Jacuzzi LED SERIES J-230 - Manual (Page 17)

page 3
Congratulations! You are now all set to get your new spa ready to use.
Simply follow this step-by-step procedure below, before long, you will be
enjoying your first glorious experience in your Jacuzzi J-200 spa.
8.0 Spa Fill Up Procedure
FoR BEST RESULTS, read each step in its entirety before proceeding
with that step:
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially for-
mulated spa cleaner. Consult your authorized Jacuzzi dealer for
additional information prior to filling spa.
• Remove filter lid then remove filter cartridge from filter bucket.
2. Fill Spa
• Place the end of your garden hose into the empty filter bucket.
CAUTION: Never fill with water from a water softener. If your
water is extremely “hard”, it is preferable to fill half-way with
hard water and the rest of the way with softened water. or, you
may fill entirely with hard water if you use a special water addi-
tive available from your authorized Jacuzzi dealer.
• Fill spa until water covers all jets but does not touch the bottom of
the lowest headrest. Do NoT oVERFILL.
IMPORTANT: Always fill your spa through the filter bucket after drain-
ing. Failure to do so may cause air to be trapped in either pump,
preventing the pump from circulating water. Remove the hose and
replace the filter cartridge.
BLUE
BLUE
BRoWN
BRoWN

2
US/Canada J-230 Models:
240 VAC, 3-Wire Connection (60Hz)
Figure-F TB
All Export J-210 / J-220 / J-230 Models:
230 VAC, 3-Wire (50Hz)
to Circuit
Board
BLK
RED
Power In
RED
RED
BLK
BLK

2
Figure-E TB
to Circuit
Board
Power In
Green
TB3
Green
TB3
GRN
WHT
WHT
BLK
BLK
BLK
RED

2
3
Figure-C TB
to Circuit
Board
Power In
GRN
WHT WHT
BLK
BLK
BLK
RED RED

2
3
All US/Canada J-210 / J-220 Convertible
Models: 120/240 VAC, 4-Wire Connection (60Hz)
Figure-D
TB
to Circuit
Board
Power In
All US/Canada J-210 / J-220 Convertible
Models: 120 VAC, 3-Wire Connection (60Hz)