Jacuzzi LED SERIES J-230 - Manual (Page 2)

Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a list
of automated functions performed by your spa. These functions are listed below
in an attempt to suppress any operational concerns you may have during the first
24-hours of ownership! Also listed below are important maintenance recommen-
dations you should observe on a regular basis to protect your new investment.
Automated Operations
Approximately two minutes after power is applied to the spa, the first skimming/
heating cycle turns on pump 1. In J-230 models, an automatic five minute “blow-
out” function also activates pump 2 for a period of five minutes to flush all lines.
Then, after five minutes, pump 2 turns off and pump 1 continues to operate for
the duration of the cycle. Note: this function only occurs during the first filtration/
heating cycle each day.
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters as
defined by the Association of Pool And Spa Professionals/USA:
Always maintain your spas filter as outlined below to ensure healthy spa water.
Refer to page 27 “Water Quality Maintenance” for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides
unsurpassed water quality! To ensure maximum water quality at all times, you
should clean the filter cartridge every three months, or earlier as necessary. See
page 24 for detailed filter cartridge cleaning/replacement instructions.
Required Water Replacement
You should replace the spa’s water every 3 months. The frequency
depends on a number of variables including frequency of use, number of users,
and attention paid to water quality maintenance. You will know it is time for a
change when you cannot control sudsing and/or you can no longer get the normal
feel or sparkle to the water, even though the key water balance measurements
are all within the proper parameters. See page 27-28 for additional information.
pH 7.2 - 7.4
Free Chlorine 3-5 ppm
Free Bromine 4-6 ppm
Total Alkalinity 100-120 ppm
Calcium Hardness 150-250 ppm