JVC MC-8200LU - Manual (Page 15)

E15
ENGLISH
[Pattern 1]
[Pattern 2]
Carrier
Drive 1
Idle Mail slot
CR : – – – MS : – – –
D1 : 0 3 6 D 2 : 0 7 5
Drive 2
Disc No.
D5 : NC
D3 : NC D 4 : NC
D 6 : NC
Unconnected
SELECT SELECT
0 7 5
Drive 3 Drive 4 Drive 5 Drive 6
4. CONTROL PANEL OPERATIONS AND LCD DISPLAY
The switch operation and LCD display system has three operation and display modes as described below.
ⅥNormal display ..... This mode includes two patterns, one of which is displayed automatically when the equipment starts
up normally. The disc numbers in the drive units are displayed in real time.
ⅥMenu display ........ This mode allows you to start user operations such as SCSI-ID No. checking and setting, internal
history display and door/panel opening.
ⅥEvent display ........ This mode overrides other modes in case of an event such as initialization after startup, mail slot
operations, setting up the door/panel opening mode or appearance of errors.
Pattern 1 is displayed automatically when the startup has succeeded normally. The display pattern will change every time the
SELECT switch is pressed.
4-2. Menu display
4-1. Normal display
1 NORMAL DISPLAY
(a See "4-1. Normal display" on this page.)
2
ERROR DISPLAY
(a See "10-4. Error history display" on page E32.)
3 ID No. DISPLAY
(a See "8-1. Display for checking the SCSI ID numbers" on page
E26.)
4 PANEL OPEN
5 DOOR OPEN MODE
(a See "5. Door Opening/Closing" on page E18.)
6
ID No. SET MODE
(a See "8. Setup of SCSI ID number of the main unit" on page
E26.)
7
COUNT DISPLAY
(a See "11. Access counts" on page E33.)
8 IMPORT/EXPORT
(a See "6-2. Import/export operation" on page E20.)
9
DRIVE DISPLAY
(a See "7-7. Drive type display" on page E25.)
SELECT
SELECT
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
2 . E R R O R D I S P L A Y
3 . I D N o . D I S P L A Y
9 . D R I V E D I S P L A Y
1 . N O R M A L D I S P L A Y
Cursor: Currently selected menu
Pressing the MODE key switch during normal display starts the menu display.
Select a menu by pressing the SELECT key and enter the selection by pressing the MODE key again.