JVC MC-8200LU - Manual (Page 18)

E18
5. DOOR OPENING/CLOSING
Once the transport locks have been released and the power has been turned on for the first time, the door is locked by an
internal safety lock in addition to the key so that the door cannot be opened with the key alone.
In order to open the door with the key under these conditions, either maintain or turn on the power supply if it has not been
turned on yet, and perform the following operations before inserting and turning the key.
1.
In the normal display mode, press the MODE Key.
(The menu display appears.)
• You cannot perform disc transport operations when the above the door open mode is being executed or the door is open.
ⅥDoor Opening
ⅥDoor Closing
1.
Close the door and turn the door opening/closing key
clockwise to lock.
2.
Press the ENTER key switch when the display shown
on the right appears.
* The screen will return to the Normal display after initialization.
The door opening/closing
key cylinder (lock)
P U S H E N T E R K E Y
T O R E S U M E
D O O R O R P A N E L
I S O P E N
The door is open.
The door is closed.
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
5 . D O O R O P E N M O D E
6 . I D N o . S E T M O D E
P U S H S E L E C T K E Y
T O O P E N T H E D O O R
P U S H S E L E C T K E Y
T O O P E N T H E D O O R
E X E C U T I N G D O O R
O P E N P R O C E S S
T H E D O O R
C A N B E O P E N E D
2.
Press the SELECT key 4 times.
("5. DOOR OPEN MODE" appears.)
3.
Press the ENTER key.
(Select and enter "5. DOOR OPEN MODE".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the execution display
[EXECUTING DOOR OPEN PROCESS] appears.
* When inserting/ejecting a drive unit, turn off the power after
the completion display [THE DOOR CAN BE OPENED] ap-
pears.
6.
Insert the door opening/closing key in the cylinder and
turn it counterclockwise to release the lock and open
the door.
Unlocked
Locked