JVC MC-8200LU - Manual (Page 24)

E24
7-6. Automatic drive detection mode
1.
While holding the "8" key on the control panel, turn on
the MC-8200LU/8600LU.
2.
When the LCD display shows "DRIVE DETECTION
COMPLETED", turn off the power of the MC-8200LU/
8600LU.
3.
Turn the MC-8200LU/8600LU on again.
Note:
After installing, adding, exchanging or removing drives, be sure to execute the auto drive detection mode to prevent any malfunction.
D E T E C T I N G D R I V E S
. . . . . P L E A S E W A I T
D R I V E D E T E C T I O N
C O M P L E E D
Drive Units
7-5. Installing the panels
1.
Attach rear and side panels.
• Screw the panels on, following the procedure in "7-1 Removing the panel" on page E22 in the reverse order.
2.
Close the door
(a See "5. Door Opening/Closing" on page E18.)
CAUTION
s Check the installation screws and cables before installing the panel. Insufficient connections may cause malfunctions.