JVC GET0635-003A - Manual

1
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing
to qualified service personnel.
3. CAUTION: Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical
instruments.
4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED OUTSIDE THE UNIT.
KD-R514
CD RECEIVER : INSTRUCTIONS/INSTALLATION
1209DTSMDTJEIN
EN
© 2009 Victor Company of Japan, Limited GET0633-001A
[UI]
Thank you for purchasing a JVC product.
Please read all instructions carefully before operation, to ensure your
complete understanding and to obtain the best possible performance from
the unit.
Basic operations
When you press or hold the following button(s)...
Main unit
Remote
controller
General operation
Turns on.
• When the power is on, pressing /I/ATT on the remote controller also
mutes the sound or pauses. Press /I/ATT again to cancel muting or resume
playback.
Turns off if pressed and held.
Selects the available sources (if the power is turned on).
• If the source is ready, playback also starts.
Adjusts the volume level.
— Selects items.
—
• Mutes the sound while listening to a source. If the source is “CD“ or “USB,“
playback pauses. Press the control dial again to cancel muting or resume
playback.
• Confirms selection.
Selects the sound mode.
• Enters tone level adjustment directly (see page 2) if pressed and held
EQ/BASS-TRE on the main unit.
—
• Enters <COLOR> setting directly (see page 3).
• Enters <COLOR SETUP> setting directly (see page 3) if pressed and held.
— Returns to the previous menu.
—
Power off : Checks the current clock time.
Power on : Changes the display information.
Warning:
If you need to operate the unit while driving, be sure
to look around carefully or you may be involved in a
traffic accident.
Control dial
Loading slot Display window
Auxiliary
input jack
Ejects the disc
Detaches the panel
Remote sensor
• DO NOT expose to
bright sunlight.
USB (Universal Serial Bus) input jack
[European Union only]
Preparations
How to attach/detach the control
panel
How to reset your unit
Reset the unit after installation is
completed.
• Your preset adjustments will
also be erased.
How to forcibly eject a disc
• You can forcibly eject the loaded disc even if the
disc is locked. To lock/unlock the disc, see page 2.
• Be careful not to drop the disc when it ejects.
• If this does not work, reset your unit.
Preparing the remote controller
(RM-RK50)
When you use the remote controller for the first time,
pull out the insulation sheet.
If the effectiveness of the remote controller
decreases, replace the battery.
Replacing the lithium coin battery
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such
as sunshine, fire, or the like.
Warning (about battery handling)
To prevent accidents and damage:
• Do not install any battery other than CR2025 or its
equivalent.
• Store out of reach of children.
• Do not recharge, short, or dismantle.
• Do not dispose of in fire.
• Do not carry around with other metallic materials.
• Wrap the battery with tape and insulate when
throwing away or saving it.
This unit is equipped with the steering wheel remote
control function.
Before operating, connect an exclusive remote
adapter (not supplied) which matches your car to the
steering wheel remote input terminal on the rear of
the unit.
• For details, refer also to the instructions supplied
with the remote adapter.
[Hold]
Insulation sheet
CR2025
1
Turn on the power.
2
3
Canceling the display demonstration
4
Select < DEMO OFF >.
5
6 Finish the procedure.
Setting the clock
1 Turn on the power.
2
3 Select < CLOCK >.
4
Select < CLOCK SET >.
5
Adjust the hour.
6
Adjust the minute.
7
Finish the procedure.
(Initial setting)
[Hold]
(Initial setting)
[Hold]
For safety...
• Do not raise the volume level too much, as this will
block outside sounds, making driving dangerous.
• Stop the car before performing any complicated
operations.
Temperature inside the car...
If you have parked the car for a long time in hot or
cold weather, wait until the temperature in the car
becomes normal before operating the unit.
EN_KD-R514[UI]_f.indd 1 EN_KD-R514[UI]_f.indd 1 12/10/09 4:56:46 PM 12/10/09 4:56:46 PM