JVC LPT1056-001A - Manual (Page 24)

24
Operation with tape
Timer recording using On Screen
Display (Continued)
8. Press i to set another timer record event and follow
steps 3 to 8.
Check that the timer event details are correct.
Press i return to screen.
If PLEASE CHECK is displayed, you have entered
incorrectly and will need to re-enter the data.
9. Press Í/I to switch your DVD+VCR to Timer
Standby mode.
The timer symbol ( ) will appear in the display
window while your DVD+VCR waits to make the
recording.
10. Press Í/I to end timer recording.
Notes:
• The DVD+VCR will automatically power off when
Timer Recording ends.
• During timer recording standby mode, the DVD and
VCR mode cannot be operated. To use the
DVD+VCR, press
Í/I. After you use the DVD or VCR,
press Í/I again to put the VCR into timer recording
standby mode.
• If at a later date you wish to delete or change any of
the settings in timer event memory you may do so
without having to enter all the timer event information
again. Simply display the timer event screen. Use
3
or 4 to select the event that you wish to delete or
change.
Press 2 to delete the event...or
Press ENTER/OK to change; then press 2 or 1 to
select; Station, Date, Start and End times and
recording speed. Press
3 or 4 to enter the correct
information.
• If Timer record events Overlap...
Make sure that the preset times of the timer recording
events do not overlap. If they do, the earlier
programme will always be given priority.
Example:
Programme 1 is programmed to start at 16:00 and
end at 17:00.
Programme 2 is programmed to start at 16:30 and
end at 17:30.
(In this case, Programme 1 will be recorded in its
entirety, but only the last 30 minutes of Programme 2
will be recorded.)
• To watch a DVD while performing a timer recording,
press TV/VCR to select VCR mode.
VJ9033CP1Z_E-EZ.book Page 24 Friday, March 11, 2005 10:12 AM