JVC CA-NXF7 - Manual (Page 51)

48
Enjoying ka
rao
k
e
■When the “ ” indicator lights up in the dis-
play window
1
Press [SETTING (KARAOKE)]
repeatedly to select “ECHO LVL”
in the display window.
Display window
2
Press [MIC VOLUME +] or [MIC
VOLUME –] repeatedly to select
the desired echo level.
Display window
• You can select one from “ECHO: 1” to
“ECHO: 6” and “ECHO: OFF”.
• Selecting “ECHO: OFF” deactivates the
echo function. (Refer to “Canceling the echo
effect” shown below.)
• The echo level increases in order of “ECHO:
1” to “ECHO: 6”.
• When no operation is made for approximately
5 seconds, the setting mode is canceled and
[MIC VOLUME +] and [MIC VOLUME –]
return to their normal operation of adjusting
the microphone volume.
In step 2 above, press [MIC VOLUME +]
or [MIC VOLUME -] repeatedly to select
the “ECHO: OFF” in the display
window.
• The “ECHO” indicator disappears in the display
window and the echo function is deactivated.
You can adjust the sound key to match your voice
range during song playback. The sound key
changes in increments of semitones.
NOTE
• When a source is selected, you can use this
function unless the loaded disc is a DVD AUDIO
or DVD VR.
• You cannot use this function for some sounds
with a sampling frequency of 32 kHz or less.
■When the “ ” indicator lights up in the dis-
play window and the song is played back
1
Press [SETTING (KARAOKE)]
repeatedly to select “KEY CON” in
the display window.
Display window
2
Press [MIC VOLUME +] or [MIC
VOLUME –] repeatedly to select
the desired setting.
• You can select one from “KEY: –6” to
“KEY: +6”.
• The sound key increases in order of
“KEY: –6” to “KEY: +6”.
• Selecting “KEY: 0” returns to the normal
sound key.
• When no operation is made for approximately
5 seconds, the setting mode is canceled and
[MIC VOLUME +] and [MIC VOLUME –]
return to their normal operation of adjusting
the microphone volume.
NOTE
• When “DVD” or “USB” is selected as the source,
and you stop playback, the setting returns to
“KEY: 0” (the initial setting).
• When you change the source, the setting returns
to “KEY: 0” (the initial setting).
Adjusting the echo effect
This indicator lights up when the function is
activated.
Canceling the echo effect
Adjusting the sound key to
match your voice range
For the locations of the remote
control buttons, refer to page 45.
NX-F3_NX-F7[US]-08.fm Page 48 Tuesday, April 29, 2008 3:50 PM