Sony SCPH-97042 - Manual (Page 51)

51
US
z Setting sound options (Audio Setup)
“Audio Setup” allows you to adjust your audio settings according to the
playback conditions. The default settings are underlined.
Select the (Audio Setup) icon in the Setup display.
To save your changes, be sure to eject the DVD before pressing the
1 (standby)/RESET button or turning off the console with the MAIN
POWER switch. Please note that changes will not be saved if you reset or
turn off the console without first ejecting the DVD.
x Audio Digital Out
Switches the method of outputting audio signals when you connect the
following equipment to the DIGITAL OUT (OPTICAL) connector using an
optical digital cable (sold separately):
• a receiver (amplifier) with a digital connector
• an audio component with a built-in Dolby Digital or DTS decoder
• an MD (MiniDisc) or DAT (Digital Audio Tape) deck
For details on connection, refer to the PlayStation
®
2 console instruction
manual.
• DIGITAL OUT (OPTICAL)
Selects whether to output signal via the DIGITAL OUT (OPTICAL) connector.
– On : Select this when you connect with an optical digital cable (sold
separately). Normally select this option. If you select “On,” select the
appropriate settings for “Dolby Digital” and “DTS.”
– Off : Select this when you do not want sound (audio) signal to be output via the
DIGITAL OUT (OPTICAL) connector.
Note
When “Off” is selected, neither “Dolby Digital” nor “DTS” can be set.