Sony DVP-NS728H - Manual (Page 13)

13
H
ook
up
s and
Se
tti
n
gs
• When you connect the player to your TV via the
SCART jack, the TV’s input source is set to the
player automatically when you start playback. In
this case, press TV t (input select) on the
remote to return the input to the TV.
• If you set “LINE” in “SCREEN SETUP” to
“RGB (COMPONENT OFF)” (page 35), the
player outputs no component video signals.
• Be sure to disconnect the HDMI cord when
moving the player.
• Do not apply too much pressure to the cabinet
wall, if you place the player on the cabinet with
the HDMI cord connected. It may damage the
HDMI OUT jack or the HDMI cord.
• When connecting or disconnecting, do not screw
in or rotate the HDMI connector.
About the CONTROL FOR HDMI
functions for ‘BRAVIA Sync’
(for HDMI connections only)
By connecting to Sony components that are
compatible with the CONTROL FOR HDMI
function with an HDMI cord (not supplied),
you can enjoy the following features:
• One-Touch Play (page 19)
• System-Power Off
When you turn the TV off by using the [/1 button
on the TV’s remote, the components compatible
with CONTROL FOR HDMI function turn off
automatically.
b
Depending on the connected component, the
CONTROL FOR HDMI function may not work.
Refer to the operating instructions supplied with the
component.
When you play a disc recorded in the NTSC
colour system, the player outputs the video
signal or the Setup Display etc. in the NTSC
colour system and the picture may not
appear on the PAL colour system
televisions. In this case, open the tray and
remove the disc.