Sharp XG-P25X - Manual (Page 27)

E-24
Setup & Connections
LENS Button
Projector Remote control Digital Image Adjustments
This function can be used to adjust the focus, zoom,
keystone, v-size and digital shift settings.
1 Press LENS to select mode. Each time LENS is
pressed, the screen changes as shown on the left.
2
Press ENTER to display test
pattern.
3
Press ∂/ƒ/ß/© to make
adjustments.
4 a. Press LENS until normal screen appears.
b. To reset the “KEYSTONE”, “V-SIZE” and
“DIGITAL SHIFT” setting, press UNDO.
• Do not touch the lens when adjusting the focus or zoom.
∂/ƒ/ß/©
UNDO
ENTER
On-screen Display
(Example: 4:3
NORMAL image)
On-screen Display
(Example: 16:9
WIDE image)
LENS
Digital Shift
or
Press ∂. Press ƒ.
Keystone setting
Trapezoidal distortion is caused when the projector
image is positioned away from the center axis of the
screen. This function allows you to correct the keystone
effect for excellent picture quality.
• Straight lines and the edges of the displayed image may appear
jagged, when adjusting the KEYSTONE setting.
V-size setting
During keystone correction an error can occur in the
aspect ratio depending on the amount of lens shift. Use
the V-SIZE fine-tuning function to correct this error.
• V-SIZE is only displayed and can only be adjusted when performing
KEYSTONE correction.
Digital shift setting
For easier viewing, this function shifts the image
projected on the screen up or down eliminating either
the upper or lower black band found in 16:9 and other
wide aspect ratios.
• Digital shift function only works with BORDER, STRETCH or SMART
STRETCH of VIDEO and DTV inputs. (See page 35 for details.)
The DIGITAL SHIFT screen is not displayed when projecting images
other than WIDE.
XG-P25X/CD (E)-b 02.3.19, 7:04 PM 24