Sony CDX-L350 User Manual

Fm / am compact disc player, Cdx-l350, Getting started

Advertising
background image

Operating Instructions

Sony Corporation

2001

Printed in Korea

FM/AM
Compact Disc
Player

CDX-L350

For installation and connections, see the supplied installation/connections
manual.

Owner’s Record

The model and serial numbers are located on the bottom of the unit.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony dealer regarding this
product.

Model No. CDX-L350 Serial No.

Welcome !

Thank you for purchasing this Sony Compact
Disc Player. You can enjoy its various features
even more with:

Supplied controller accessory

Card remote commander RM-X115

Warning

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the

equipment and receiver.

— Connect the equipment into an outlet on a

circuit different from that to which the
receiver is connected.

— Consult the dealer or an experienced radio/

TV technician for help.

You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.

CAUTION

The use of optical instruments with this product
will increase eye hazard.

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the RESET button with a pointed object,
such as a ball-point pen.

Note
Pressing the RESET button will erase the clock
setting and some stored contents.

RESET button

Specifications

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
5 % total harmonic distortion.

CD player section

Signal-to-noise ratio

90 dB

Frequency response

10 – 20,000 Hz

Wow and flutter

Below measurable limit

Laser Diode Properties

Material

GaAlAs

Wavelength

780 nm

Emission Duration

Continuous

Laser output power

Less than 44.6 µW*

* This output is the value measured at a distance of

200 mm from the objective lens surface on the
Optical Pick-up Block.

Tuner section

FM

Tuning range

87.5 – 107.9 MHz

Antenna terminal

External antenna connector

Intermediate frequency

10.7 MHz

Usable sensitivity

11 dBf

Selectivity

75 dB at 400 kHz

Signal-to-noise ratio

65 dB (stereo),
68 dB (mono)

Harmonic distortion at 1 kHz

0.7 % (stereo),
0.5 % (mono)

Separation

33 dB at 1 kHz

Frequency response

30 – 15,000 Hz

AM

Tuning range

530 – 1,710 kHz

Antenna terminal

External antenna connector

Intermediate frequency

10.7 MHz/450 kHz

Sensitivity

30 µV

Power amplifier section

Outputs

Speaker outputs
(sure seal connectors)

Speaker impedance

4 – 8 ohms

Maximum power output 50 W

×

4 (at 4 ohms)

General

Outputs

Audio output
Power amplifier control
Power antenna relay control

Tone controls

Bass ±10 dB at 20 Hz
Treble ±10 dB at 20 kHz

Power requirements

12 V DC car battery
(negative earth)

Dimensions

Approx. 178

Ч

50

Ч

176 mm

(7

1

/

8

Ч

2

Ч

7 in.)

(w/h/d)

Mounting dimensions

Approx. 182

Ч

53

Ч

161 mm

(7

1

/

4

Ч

2

1

/

8

Ч

6

3

/

8

in.)

(w/h/d)

Mass

Approx. 1.2 kg (2 lb. 10 oz.)

Supplied accessory

Parts for installation and
connections (1 set)
Front panel case (1)
Card remote commander
RM-X115

Design and specifications are subject to change
without notice.

3-227-643-11 (1)

Setting the clock

The clock uses a 12-hour digital indication.

Example: To set the clock to 10:08

1

Press

(DSPL)

for 2 seconds.

The hour indication flashes.

1

Press either side of the volume +/–
button to set the hour.

2

Press (SEL).
The minute indication flashes.

3

Press either side of the volume +/–
button to set the minute.

2

Press

(DSPL)

.

The clock starts. After the clock setting is
completed, the display returns to normal
play mode.

Detaching the front panel

You can detach the front panel of this unit to
protect the unit from being stolen.

Caution alarm

If you turn the ignition switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds.

1

Press

(OFF)*

.

CD playback or radio reception stops (the
key illumination and display remain on).

* If your car has no ACC position on the ignition

switch, be sure to turn the unit off by pressing
(OFF) for 2 seconds to avoid car battery drain.

2

Press

(RELEASE)

, then pull it off towards

you.

Notes
If you detach the panel while the unit is still

turned on, the power will turn off automatically to
prevent the speakers from being damaged.

• Do not drop or put excessive pressure on the front

panel and its display window.

• Do not subject the front panel to heat/high

temperature or moisture. Avoid leaving it in
parked cars or on dashboards/rear trays.

Tip
When carrying the front panel with you, use the
supplied front panel case.

(OFF)

(RELEASE)

Attaching the front panel

Attach part A of the front panel to part B of the
unit as illustrated and push the left side into
position until it clicks.

Note
Do not put anything on the inner surface of the
front panel.

A

B

Advertising
This manual is related to the following products: