Sony CMT-EP404 - Manual (Page 11)

Tuner
11 GB
Setting presets through
manual tuning
1
Press TUNER (TUNER/BAND on the
remote) repeatedly to select “FM” or
“AM”.
2
Turn and hold TUNING +/– (or press
and hold TUNING + or TUNING – on the
remote) repeatedly to tune in the
desired station.
3
Press TUNER MEM (TUNER MEMORY
on the remote).
The preset number starts flashing.
The stations are stored from preset number
1.
-
4
Press ENTER.
The station is stored.
5
Repeat steps 1 to 4 to store other
stations.
Other Operations
To
Tune in a station with a
weak signal
Change the preset
number
Set another station to
an exsisting preset
number
Do this
Follow the procedure
described in “Setting
presets through manual
tuning”.
Start over from step 1.
Start over from step 1.
After step 3, press
PRESET + or –
repeatedly to select the
preset number where you
want to store the other
station and then press
ENTER.
Preset number
To erase all preset stations
1 Press and hold TUNER MEM (TUNER
MEMORY on the remote) until “ERASE”
and “PRESET” appear alternately.
2 Press ENTER.
All preset stations are cleared.
To change the AM tuning interval
(except for the European model)
Disconnect the power cord from the wall outlet
first, and then set the AM FREQ STEP switch
at the rear to 9 kHz or 10 kHz.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 10).
1
Press TUNER (TUNER/BAND on the
remote).
2
Press PRESET + or – repeatedly to tune
in the desired preset station (or RDS
station name*).
The preset number appears in the display
for a few seconds.
When only one station is preset, only that
station is tuned.
* European model only.
continued