Sharp VC-MH835HM User Manual

Page 12

Advertising
background image

10

www.sharp.co.uk/support

INSTALLING YOUR VCR

AUTO INSTALLATION OF A SATELLITE RECEIVER/
CABLE BOX CONTINUED

12.

Press[

/

]to select SAT NO.

Sky Digital Installation

If you wish to install the preset Sky Digital receiver channel list, enter the code

035

. While

the arrows on the screen are moving from VCR to SAT a test signal of channel 012 is being

sent out from the VCR. Please ensure your Sky Digi box responds to this signal (“

012

channel unavailable” will appear on the screen). A list of preset digital channels can be

found at the back of the operation manual.

Other Analogue Satellite Systems

Refer to the table at the end of this manual. Look for the make of your satellite receiver

and use the

NUMBER BUTTONS

to enter the first code number listed. For example

number 8 should be entered 0 0 8. Your satellite should now change to preset channel 12.

NOTES:

13.

Once your Satellite Receiver has responded to the

VCR press the

SET

button to continue.

The VCR will attempt to copy the TV preset list

(NexTView, Smart Link, Easy Link and Megalogic

compatible TV’s only). During the copying process

the display will show the TV presets that are being

copied. If the VCR is unable to copy the TV preset list

the terrestrial and satellite channels will be

automatically installed. (Auto install may take a few

minutes.)

See next page to continue

• If your satellite receiver has not changed to preset channel 12 enter the next code

number on the list. Continue until the receiver shows preset channel 12, then continue

from point 13.

• If your satellite receiver is not in the manufacturers list or after entering all the numbers

listed for your receiver, the receiver preset channel has still not changed to 12, enter

001

and check your receiver. If it has not changed press

to select

002

and re-check. If it

has changed continue from point 13.

• If there is still no response, try adjusting the position of your satellite receiver.

If you connect a Satellite Receiver to the VCR for the first time, after auto-installation

or you are replacing your existing Satellite Receiver, you may need to perform a

complete Auto Installation Procedure to re-tune your VCR. (Refer to

SATELLITE

RECEIVER / CABLE BOX INSTALLATION

.)

MENU SELECT
BUTTONS

SET

REMOTE

SET

TINS-A082UMN1.book Page 10 Monday, November 4, 2002 2:33 PM

Advertising