Sony FST-GTK1I - Manual (Page 21)

model name [FST-GTK2i]
[4-186-872-11(2)] GB
21 GB
Ad
ditional Inf
o
rmation
filename[D:\NORM'S JOB\SONY HA\SO0098\G-
Tank_PMRF\4186872112_GB\GB07ADD.fm] masterpage:Right
iPod
If the iPod does not operate properly,
check that you have removed the protect
case of the iPod. If the problem persists,
use the following troubleshooting guide to
remedy the problem.
There is no sound.
• Make sure the iPod is connected
securely.
• Make sure the iPod is playing music.
• Adjust the volume.
• Depending on the contents of the iPod,
it may take time to start playback.
• You are using an unsupported iPod. See
“Compatible iPod models with this
unit” (page 27) for the supported device
types.
The sound is distorted.
• Reduce the volume.
• Set the “EQ” setting of the iPod to “Off”
or “Flat”.
The iPod cannot be operated.
• Disconnect the iPod and connect the
iPod again.
• You are using an unsupported iPod. See
“Compatible iPod models with this
unit” (page 27) for the supported device
types.
The iPod cannot be charged.
• Make sure you press the POWER on the
back panel.
• Make sure the iPod is connected
securely.
“OVER CURRENT” appears.
• A problem has been detected with the
level of electrical current from the iPod.
Press POWER on the back panel to turn
off the unit and remove the iPod. Make
sure there is no problem with the iPod. If
this display pattern persists, contact
your nearest Sony dealer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or
“ST” flashes in the display)
• Set the proper band and frequency
(page 12).
• Connect the antenna properly (page 9).
• Find a location and an orientation that
provide good reception, then set up the
antenna again.
• The supplied FM lead antenna receives
signals along its entire length, so make
sure you extend it fully.
• Keep the antennas away from the power
cord, the USB cable, the iPod and
subwoofer cable (FST-GTK2i only) to
avoid picking up noise.
• Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
• Turn off nearby electrical equipment.
A stereo FM program cannot be
received in stereo.
• Press FM MODE repeatedly until
“MONO” disappears from the display.
Optional components
There is no sound.
• See general item “There is no sound.”
(page 19) and check the condition of the
unit.
• Connect the component properly
(page 9) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
the way.
• Turn on the connected component.
• Refer to the operating instructions
supplied with the connected component
and start playing.
Continued
l