Sony MDS-JE770 - Manual (Page 11)

Rec
o
rd
ing
to M
D
s
masterpage:Left
(3 column)
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
11
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
Recording to MDs
If the MD has been partially recorded,
recording starts after the recorded tracks.
1
Turn on the amplifier and program
source, and select the source on the
amplifier.
2
Press ?/1 to turn on the deck.
The STANDBY indicator turns off.
3
Load a recordable MD into the slot
(page 20).
4
Press INPUT repeatedly to select the
input jacks (connector) connected to
the program source.
1) MDS-JE770 European model only
5
Press REC z .
The deck changes to recording pause.
6
If necessary, adjust the recording level.
For details, see “Adjusting the recording
level” on page 16.
7
Press H or X .
Recording starts.
8
Start playing the program source.
Operations you may want to do
during recording
2) The track number increases by one.
Recording to an MD
When the source is
connected to the Set INPUT to
DIGITAL OPTICAL IN1 or
IN2 connector OPT1 or OPT2
DIGITAL OPTICAL IN
connector OPT or D-IN
DIGITAL COAXIAL IN jack 1) COAX
ANALOG IN jacks ANALOG or
A-IN
To Press
Stop recording x
Pause recording X
Resume recording after
pausing
2)
H or X
Eject the MD EJECT A after stopping
recording
To change the display while
recording
Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly to change the display.
Each press of the button changes the display
cyclically as follows:
MDS-JE770
Track number and recorded time of the current
track
t Level of the input signal (setting value
of the recording level) t Sampling frequency
indication 3)
3) “FS -- kHz” appears while the analog signal is
input.
MDS-JE470
Track number and recorded time of the current
track
t Remaining recordable time 4) on the
MD
t Level of the input signal t Track
name 5)
4) Time shown in the display differs depending on
the setting of REC MODE.
5) “No Name” appears when the track has no name.