Sony MDS-JE770 - Manual (Page 37)

O
the
r Func
tion
s
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
37
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
masterpage:Left
(3 column)
6
Turn AMS (or press ./>
repeatedly) to select the time to be
turned off (“30min,” “60min” (factory
setting), “90min,” or “120min”), then
press AMS or YES.
7
Press MENU/NO.
Tip
You can check the remaining time.
Once you turn on Sleep Timer, the remaining time is
displayed when you select “Sleep” in Setup Menu.
By connecting a timer (not supplied) to the
deck, you can start and stop playing/recording
operations at specified times. For further
information on connecting the timer or setting
the starting and ending times, refer to the
instructions that came with the timer.
Playing an MD using a timer
1
Do steps 1 to 3 of “Playing an MD” on
page 20.
2
Press PLAY MODE repeatedly to select
the play mode you want.
To play only specific tracks, create a
program (see page 22).
To specify the time for the end of playing,
press H to start playing, then go to step 3.
3
Set TIMER on the deck to PLAY.
4
Set the timer as required.
5
After you have finished using the timer,
set TIMER on the deck to OFF.
Recording to an MD using a
timer
1
Do steps 1 to 6 of “Recording to an MD”
on page 11.
2
Press x .
If you want to specify the time for the end of
recording, do steps 7 and 8 of “Recording to
an MD” on page 11.
3
Set TIMER on the deck to REC.
4
Set the timer as required.
5
After you have finished using the timer,
set TIMER on the deck to OFF. Then
change the deck to standby mode by
plugging the AC power cord of the deck
into a wall outlet or set the timer to
continuous operation.
If TIMER is left at REC, the deck will
automatically start recording the next time
you turn on the deck.
Make sure to change the deck to
standby mode within a week after
timer recording is completed.
The TOC on the MD is updated and recorded
contents are written to the MD when you turn
on the deck. If the recorded contents have
disappeared, “Initialize” flashes when you turn
on the deck.
Notes
• It may take about 30 seconds after the deck is turned
on until recording starts. When recording at a
specified time using the timer, be sure to take this
time into account when setting the recording start
time.
• During timer recording, new material is recorded
from the end of the recorded portion on the MD.
However, when timer recording is set with the
Group function on but no group is specified, the
material is recorded into a new group.
Using a timer (MDS-JE770
only)