Sony MDS-JE770 - Manual (Page 13)

Rec
o
rd
ing
to M
D
s
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
13
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
masterpage:Left
(3 column)
Recording into a new group
You can create new groups by CD album or
artist, etc.
1
Do steps 1 to 4 of “Recording to an MD”
on page 11.
2
Press GROUP ON/OFF.
The GROUP ON/OFF button lights up.
Press TIME to display the remaining
recordable time.
3
Press REC z .
“New Group” flashes and the deck changes
to recording pause.
4
Do steps 6 to 8 of “Recording to an MD”
on page 11.
To continue and record into another new
group, press x repeatedly after the
recording to display the disc name and the
total number of groups, then do steps 3 and
4.
If “Group Full!” appears when you
press REC z to start recording
You cannot start recording because there is
insufficient character space for group
management.
Delete unnecessary characters (disc name or
track names) until group recording is possible
(see page 31).
Notes
• The new group is added after any existing groups
with tracks registered into them.
• Up to 99 groups can be registered on a single MD.
• If “Group Full!” appears while recording, track
numbers are not marked.
Recording into an existing
group
You can add tracks to an existing group.
1
Do steps 1 to 4 of “Recording to an MD”
on page 11.
2
Press GROUP ON/OFF.
The GROUP ON/OFF button lights up.
3
Press GROUP SKIP repeatedly until the
group you want to record in appears.
4
Press REC z .
“New Track” flashes and the deck changes
to recording pause.
5
Do steps 6 to 8 of “Recording to an MD”
on page 11.
If “Group Full!” appears when you
press REC z to start recording
You cannot start recording because there is
insufficient character space for group
management.
Delete unnecessary characters (disc name or
track names) until group recording is possible
(see page 31).
Notes
• The recorded track is added to the end of the group.
• When you newly record a track into an existing
group, the track numbers following the newly
recorded track may change when the Group function
is turned off.
• If “Group Full!” appears while recording, track
numbers are not marked.
After recording
Press EJECT A to remove the MD or press
?/1 to turn off the deck.
“TOC” or “TOC Writing” starts flashing. The
TOC is updated and recording is completed.
Before disconnecting the AC power
cord
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the deck. Do not disconnect the AC
power cord before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC Writing” is flashing) to ensure a
complete recording.
Automatic conversion of digital
sampling rates
A built-in sampling rate converter automatically
converts the sampling frequency of various
digital sources to the 44.1 kHz sampling rate of
the MD deck. This allows you to monitor and
record sources such as 32- or 48-kHz DAT tape
or satellite broadcasts, as well as the CDs and
MDs.
Notes on recording
continued