Southwing SH305 - Manual (Page 3)

3
® Bluetooth is a registered trademark owned by Bluetooth SIG, Inc. U.S.A. and licensed to SouthWing.
INTRODUCTION
Thank you for choosing a Bluetooth ®
product from SouthWing.
This user guide provides all the infor-
mation you will need to use and care
for your product.
All relevant information regarding your
SouthWing product can be found on
the support section of our website:
www.south-wing.com
1. CHARGING THE HEADSET
You will need to charge the battery of
your Headset. To do so, follow these
steps:
1. Plug the power supply into a power
point
2. Plug the connector of the power
supply into the USB Charging Socket
[1]. The Indicator Light [2] will turn
green to indicate the Headset battery
is charging
3. Once the Indicator Light [2] turns
off, the Headset is fully charged and
can be removed from the power
supply
Please Note:
· The Headset will not function while
charging.
· If the Indicator Light [2] remains off when
charging, the battery is already fully charged
and does not require further charging.
· To maximise battery life, do not charge the
Headset for extended periods of time.
· Full battery capacity will be achieved after
two or three full charge/discharge cycles.
· When your battery is flat, it takes up to four
hours to completely charge your headset.
2. PAIRING THE HEADSET
Auto-pairing
For added convenience, your headset
has an auto-pairing function so that
when you turn the headset on for the
first time, it is already in pairing mode
(you will also hear a series of high
tones). Then, follow these steps:
1. Put the mobile phone into pairing
mode (see the instructions which
came with your phone). Ensure that
the mobile phone is no more than 1
metre away from the headset
2. Enter the PIN number: 1111.
If pairing is successful, the Indicator
Light [2] will begin flashing every 3 se-
conds.
Normal pairing
You will need to follow the steps below
if you want to pair your Headset with
another mobile phone.
You will be able to pair your Headset
with up to 3 devices.
1. Ensure the Headset is off
2. Press and hold the On/Off Button
[3] for about 5 seconds until the
Indicator Light [2] flashes twice every
second (you will also hear a series of
high tones)
Then complete normal pairing process
by following point 1 and 2 of the auto-
pairing section above.
3. WEARING AND CARRYING
THE HEADSET
You can wear your Headset on either
ear and carry it in different ways using
the rotating Multi-function Arm [8].