Sangean DT-300 - Manual (Page 13)

13
11
11
5
8
12
13 14
station is selected to take its place. When the memory is full for a
particular band pressing the Memory Selection Button will cause all
the positions to flash. In this case,select the desired position. press the
Memory Selection Switch and the original station will be eliminated
and the new station will take its place.
D.Selecting Memory Presets
Turn on receiver by pressing On/Off Button . Select desired band by
pressing Band Selector Button Move the Select Cursor to the
Memory Positions by Pressing Select Button . Select desired
preset position using Memory Up/Down Buttons or
E. Automatic Memory Preset System (APS)
This receiver is equipped with an Automatic Memory Preset System that
will automatically select. based upon signal strength. and assign positions
to stations on the band you select.Turn on receiver by pressing
L
H