Sangean DT-300 - Manual (Page 7)

7
3
8
13 14
8
8
Setting Time
When batteries are installed for the first time the LCD display time digit will
flash indicating that the time needs to be set. The clock can be set with
the power off but the lockswitch must be off. To set time press Time
Set Button for more then 2 seconds until hour digit flashes. While
hour digit is flashing use Time Adjust Buttons and to select the
correct hour. Pressing Time Set Button again will cause the minite digit
to flash. Use same procedure as hour set to set minite set. Press Time Set
Button to finalize time setting.
Long Term Alarm Set
Press Standby Button for more than 2 seconds until hour digit flashes.
Press Time Adjust Button and to set the required hour and then
Press the Standby Button again to cause the minute button to flash.
Set minute desired same way as hour was set. Press Standby Button
again to finalize setting.
13 14
11
11