Summit HP-1S - Manual (Page 9)

ASSEMBLY & DISASSEMBLY
ASSEMBLY
A. Opening the wheelchair
Standing at one side of the wheelchair, tilt it to one side, and push down firmly on the
seat rails. The seat should be locked into the receivers on the wheelchair side frame
when the chair is fully opened.
B. Installing the batteries (not provided)
Note: We recommend using a battery with 12 volt
34AH (for example, U-1) for better performance.
Each battery weighs more than 23 lbs. as an
average. Please seek help if you cannot lift them
by yourself.
Put the batteries into the battery boxes. Using the
screws, washers, and nuts provided from the
battery supplier, connect the red line to the
Positive (+) terminal of a battery while connecting
the black line to the Negative ( ) terminal of the
same battery (Fig. 2). Close the box properly and
carry it with the strap. Apply the same
connecting method to both batteries.
Fold down the battery bars on each side of the frame so that you can slide the
battery boxes underneath the seat (Fig. 3). The battery box with the reset button and
two outlet connectors should be put underneath the power chair first. The outlet
connectors of the battery boxes should be put on the same side for connection.
Connect the two battery connectors (Fig. 4). Put the battery supporting bar at the
back of the battery box. Screw on the battery knobs to tightly fasten the bar (Fig. 5).
Page 7
Battery Bar
Fig. 3
Fig. 2
Fig. 4 Fig. 5
Battery Knobs
Battery
Connector
+