Sony FST-ZX100D - Manual (Page 66)

66 US
Other operations
Notes
• You cannot select the Play Timer and the Timer
Recording at the same time.
• If you use the Timer Recording and the Sleep Timer
at the same time, the Sleep Timer has priority.
• The Timer Recording will not be activated if the
system is turned on or if “STANDBY” flashes in the
display.
• The volume is reduced to minimum during Timer
Recording.
• Do not operate the system from the time the system
turns on until the recording starts (about 30 seconds
before the preset time).
Tips
• The system turns on 30 seconds before the preset
time.
• When Timer Recording is selected, “REC” lights up
in the display.
The demonstration display and the clock display
can be turned off to minimize the amount of
power consumed during standby mode (Power
Saving Mode).
Press DISPLAY repeatedly while the
system is turned off until the
demonstration display and the clock
display disappears.
To cancel Power Saving Mode
Press DISPLAY repeatedly while the system is
turned off. Each time you press the button, the
display changes cyclically as follows:
Demonstration
1) t Clock 2) t No display
(Power Saving Mode)
1) The display changes and the indicators flash even
when the system is turned off.
2)
“– –:– –” appears in the display if you have not set
the clock.
Note
You cannot perform the following operations during
Power Saving Mode:
– Setting the clock (page 13).
– Changing the AM tuning interval (page 48).
– Turning on the system by pressing DVD, TUNER/
BAND, TAPE A/B, TV/SAT or VIDEO on the unit.
Tips
• The timer continues to operate in Power Saving
Mode.
• The ?/1 indicator lights up in red even in Power
Saving Mode.
To Do this
Check the setting 1 Press TIMER MENU.
“TIMER SELECT?” flashes
in the display.
2 Press ENTER.
3 Press
V
or
v
repeatedly to
select “REC SELECT?”,
then press ENTER.
Change the setting Start from step 1.
Cancel the Timer
Recording 1 Press TIMER MENU.
“TIMER SELECT?” flashes
in the display.
2 Press ENTER.
3 Press
V
or
v
repeatedly to
select “TIMER OFF?”, then
press ENTER.
Display
Turning off the display
— Power Saving Mode