Setting up the function, Setting up the function by using the lcd panel, Select the flash mode – Samsung Digimax 130 User Manual

Page 30

Advertising
background image

30

SETTING UP THE FUNCTION

Setting up the function by using the LCD panel

The flash mode can only be set under RECORD mode.

There are 4 modes available: Auto flash, Red-eye reduction, Fill-in flash and Flash off.

The default setting is Auto flash.

Use the flash mode that is best suited for the environment.

To change the setting, press the Flash mode button until the desired mode is highlighted.

In low light conditions, flash will automatically fire to obtain
the correct exposure.

Pre-Flash to reduce red eye effect

The flash will fire, regardless of the prevailing lighting

conditions.

The flash is disabled.

Select the Flash mode

Auto flash

Fill-in flash

Flash off

Red-eye reduction

Note

When a subject is closer than 1m there will be an additional exposure (2~3times) to

ensure the correct lighting levels. Please do not move until the main flash fires.

Using the flash frequently will reduce the life of the batteries.

Under normal operating conditions, the charging time for the flash is normally under

10 seconds. If the batteries are weak, the charging time will be longer.

If you take a outdoor photography or the subject is in shady place, set the flash mode

Fill-in flash to get a good result.

If you take a picture in dark place and the flash mode is off, LOW LUMINANCE

message will display on the LCD monitor. In addition, it may cause the camera to lock the

Shutter automatically. In this case, set the flash mode to Auto flash and take a picture again.

Advertising