Sharp UX-600M - Manual (Page 13)

UX600MU-ISUN RT <P=001>
Ch
ap
te
r
1
Installation
Unpacking Checklist
After unpacking your fax, make sure you have all the items shown below. If any
are missing, contact your dealer or retailer.
Handset
Handset cord
Telephone
line cord
Rapid key
labels
Operation manual
Paper tray
cover
Paper tray
3 gears and
1 flange
Sample
imaging film
Multifunction
Interface kit
(two cables, PC
Interface box,
CD-ROM)
Original document
support (located
between box and
packing case)
Points to keep in mind when setting up
♦
The fax must be installed on a level surface.
♦
Keep the fax away from air conditioners, heaters, direct sunlight, and dust.
♦
Provide easy access to the front, back, and sides of the fax. In particular,
keep the area in front of the fax clear, or the original document may jam as
it comes out after scanning.
♦
If the fax is moved from a cold to a warm place, it is possible that condensa-
tion may form on the reading glass, preventing proper scanning of docu-
ments for transmission. To remove the condensation, turn on the power and
wait approximately two hours before using the fax.
♦
If your area experiences a high incidence of lightning or power surges, we
recommend that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased at most telephone specialty stores.
1