Sharp UX-600M - Manual (Page 39)

UX600MU-IPAD RT <P=001>
Storing Numbers for Automatic Dialing
Automatic dialing is a quick and convenient way of dialing which is done by
either pressing a Rapid Key (Rapid Key Dialing), or pressing the SPEED DIAL
key and entering a 2-digit number (Speed Dialing). Automatic dialing can be
used for both fax transmissions and voice calls.
To use automatic dialing, you must first store the full number in your fax and as-
sign a 2-digit Speed Dial number to it. You can also enter a name which appears
in the display when the number is dialed. Up to 99 numbers can be stored.
♦
Speed Dial numbers from "01" to "38" can be used for both Rapid Key Di-
aling and Speed Dialing; Speed Dial numbers from "39" to "99" can only
be used for Speed Dialing.
♦
To allow easy identification of the Rapid Keys, attach each strip of Rapid
Key labels above the appropriate row of Rapid Keys. The arrangement of
the keys is shown in "A Look at the Operation Panel" in this chapter. Each
time you store a number for Rapid Key Dialing, write the name of the party
above the appropriate key.
Storing numbers
Comments:
•
You may need to add a pause between certain digits in the number to allow
time for connection. For example, if you are on a PBX telephone system that
requires an access number to be dialed (such as "9") to access an outside line,
you will need to enter a pause between the access number and the
telephone/fax number of the other party. Pauses are entered by pressing the
REDIAL key (2 seconds per pause). Several pauses can be entered in a row.
♦
If you make a mistake, press the HOLD/SEARCH key to move the cursor
back to the mistake, then enter the correct number or letter. (To move the
cursor forward, press the SPEAKER key.)
1
Press the keys shown at right.
FAX/TEL. # MODE will appear in the
display.
2
Press "1" to select SET.
FUNCTION
3
1
Chapter 2 Initial Settings
27