Sharp UX-600M - Manual (Page 73)

<P=002>
4
Press the START key if you entered a
Speed Dial number or a full number.
•
The document will be scanned and
stored in memory. Your fax will then
dial the receiving machine and trans-
mit the document (redialling will be
done automatically if necessary).
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL will appear in the display.
♦
Press the START key if you want to transmit the pages which have been
stored up to that point in memory. The remaining pages will be ejected
from the feeder. After transmission, the memory will be cleared and you
can transmit the remaining pages. You will also need to transmit the page
which was being scanned when the memory filled up.
♦
Press the STOP key if you want to cancel the entire transmission.
Substitute reception
This is a back-up function which is automatically activated if your fax runs out
of paper, the printing ribbon needs replacement, or the paper jams.
When you have received a document in memory, FAX RX IN MEMORY will
appear in the display, alternating with OUT OF PAPER, FILM END, or PAPER
JAM. When you add paper, replace the imaging film, or clear the jam, the stored
documents will automatically print out.
♦
If you received documents in memory because the fax ran out of paper, be
sure to add paper which is the same size as the paper previously used. If not,
the document print-out size may not match the size of the printing paper.
Caution!
•
When documents are stored in memory, do not turn the power off. This will
erase all of the contents.
•
If documents received in memory are lost due to a power failure or other
interruption in the power supply, a "CLEAR REPORT" will be printed out
when the power is restored. This gives information about the receptions lost,
including the fax numbers of the transmitting machines if they are available.
START
Chapter 8 Special Functions
61