Installation of the water dispenser line, Connect the water line to the refrigerator – Samsung RB195ZABB User Manual

Page 13

Advertising
background image

- Water line Kit and water filter are not covered by Samsung Warranty and manufacturer(or dealer, installer)

of them should be responsible for the defect and all the loss caused by water filter & water line kit .

- Filter should be replaced according to manufacturer (or dealer)'s instruction.
- To order additional water filters, please contact the manufacturer (or dealer) of the filter.

NOTE

INSTALLATION OF THE WATER DISPENSER LINE

13

- Shut off the main water supply line and turn

the Ice maker to the off position.

- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker

installation kit.

- After connecting the water supply with water

filter, turn on water supply and flush 4 or more
gallons into a bucket to clear the water filter

• This water line installation is not warranted by the refrigerator or icemaker manufacturer. Follow these

instructions carefully to minimize the risk of expensive water damage.

• Banging pipes (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and

lead to water leakage or flooding. Call a qualified plumber to correct the problem before installing the water
supply line to the refrigerator.

• To prevent burns and product damage, do not hook up the water line to the hot water line.

• Do not install the icemaker tubing in areas where temperatures fall below freezing.

• When using any electrical device (such as a power drill) during installation, be sure the device is insulated or

wired in a manner to prevent electric shock.

• All installations must be in a accordance with local plumbing code requirements.

1. Cold Water line

2. Pipe Clamp.

3.Copper (or Plastic) line

4.Compression Nut

5.Compression Sleeve

6.Shut Off Valve

7.Packing Nut.

Before You Install the water line

Connecting to water supply line

- Slip the compression nut through the plastic tube.

- After inserting the compression nut into plastic tube,

tighten the compression nut onto 1/4” compression

fitting(union).

- You can purchase the necessary parts through retail outlets such as Wal-nart, The Home Depot and Lowe’s
- Waterline must be connected to drinkable water only
- Compression fitting and nut will be given inside of ice bucket.

NOTE

Do not overtighten the compression nut.

NOTE

- Slip the compression ferrule and nut on copper(or plastic) tubing

as shown.
After inserting the sleeve, tighten the compression nut onto the
compression fitting(union).

- Turn water on and check for any leakege.

Compression

Nut

Sleeve

Compression

fitting

Ferrule

Compression
Nut

Connect the water line to the refrigerator

Advertising