Sony WEGA KV-27FS210 - Manual (Page 13)

Using the Remote Control
5
Programming the Remote Control
In order to use your remote control with other equipment, you need to program your remote
control. Use the following procedure to program the remote control.
1
Check the list of “Manufacturer’s Codes” on page 6 and find the three-digit code number
for the manufacturer of your component. If more than one code number is listed, use the
number listed first.
2 Press .
3 Press or button to indicate the type of component you want to program with
the remote control.
4
Use the buttons to enter the three-digit manufacturer’s code number.
5
Press .
6
To check if the code number works, aim the TV’s remote control at the component and
press on the green POWER button (VCR/DVD, SAT/CABLE, TV) that corresponds with
that component. If it responds, you are done. If not try using another code listed for that
manufacturer.
✍
The and button will flash when you press .
✍
You must do step 4 within 10 seconds of step 3, or you must redo steps 2 and 3.
✍
If you have problems programming your remote control, see “Troubleshooting” on page 43.
0 9