Additional information, Precautions – Sony CMT-EP305 EN User Manual

Page 18

Advertising
background image

18

GB

On operation

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.

• When you move the system, take out any discs.

If you have any questions or problems concerning
your stereo system, please consult your nearest Sony
dealer.

Notes on CDs

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out.

• Do not use solvents.
• Do not expose the CD to direct sunlight or heat

sources.

• Discs with non-standard shapes (e.g., heart, square,

star) cannot be played on this system. Attempting to
do so may damage the system. Do not use such
discs.

Note on CD-R/CD-RW playback

Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt., recording
condition or the drive’s characteristics. Besides, the
discs, which are not yet finalized at the end of
recording cannot be played back.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild
detergent solution.

Additional information

Precautions

On operating voltage

Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.

On safety

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.

• Unplug the system from the wall outlet (mains) if it

is not to be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the stereo system and have the
component checked by qualified personnel before
operating it any further.

• The AC power cord must be changed only at a

qualified service shop.

• The nameplate is located on the bottom exteror.

On placement

• Place the unit in a location with adequate

ventilation to prevent heat build-up the unit.

• Do not place the unit in an inclined position.
• Do not place the unit in locations where it is;

— Extremely hot or cold
— Dusty or dirty
— Very humid
— Vibrating
— Subject to direct sunlight.

• Use caution when placing the unit or speakers on

surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.

On heat buildup

• Although the unit heats up during operation, this is

not malfunction.

• Place the unit in a location with adequate

ventilation to prevent heat build-up in the unit.

If you continuously use this unit at a large volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.

Advertising
This manual is related to the following products: