Sony CMT-BX3R - Manual (Page 11)

CMT-BX3R.GB.3-095-505-11(1)
11 GB
G
etting S
tar
ted
 Power
For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
Connect the power cord to a wall socket.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only
for models equipped with an adaptor).
When carrying this system
1
Remove a disc to protect the CD
mechanism.
2
Press CD  to select the CD
function.
3
Hold down TUNER/BAND  and
DSGX  on the unit, and press  
on the unit until “STANDBY” appears.
4
After “LOCK” appears, unplug the
power cord.
To use the remote
Slide and remove the battery
compartment lid  , and insert the two
supplied R6 (size AA) batteries,  side
first, matching the polarities shown
below.
Notes
 With normal use, the batteries should last for
about six months.
 Do not mix an old battery with a new one or
mix different types of batteries.
 If you do not use the remote for a long period
of time, remove the batteries to avoid damage
from battery leakage and corrosion.
Setting the clock
Use buttons on the remote to set the
clock.
1
Press /  to turn on the
system.
2
Press CLOCK/TIMER SET  .
If the current mode appears on
the display, press /

repeatedly to select “CLOCK SET”
and then press ENTER  .
3
Press /  repeatedly
to set the hour, and then press
ENTER
 .
4
Use the same procedure to set
the minutes.
The clock settings are lost when you
disconnect the power cord or if a
power failure occurs.
To display the clock when the system
is off
Press DISPLAY  . The clock is displayed
for about 8 seconds.