Settings for the display – Sony DAV-DZ270 User Manual

Page 54

Advertising
background image

54

GB

Select settings according to the TV to be
connected.

x [TV TYPE]

You can select the aspect ratio of the connected
TV.

[16:9]: Select this when you connect a wide-
screen TV or a TV with a wide mode function.

[4:3 LETTER BOX]: Select this when you
connect a 4:3 screen TV. Displays a wide picture
with bands on the upper and lower portions of
the TV screen.

[4:3 PAN SCAN]: Select this when you connect
a 4:3 screen TV. The system automatically
displays the wide picture on the entire screen
and cuts off the portions that do not fit.

Note

• Depending on the DVD, [4:3 LETTER BOX] may be

selected automatically instead of [4:3 PAN SCAN] or
vice versa.

x [PROGRESSIVE (COMPONENT OUT)]

You can set the progressive signal that is output
from the COMPONENT VIDEO OUT jacks to
on/off. For details, see “Does your TV accept
progressive signals?” (page 29).

[OFF]: The system outputs interlace signals.
[ON]: The system outputs progressive signals.
When you select [ON], follow the Steps below.

1

Select [ON], then press

.

The confirmation display appears.

2

Press

C/c to select [START].

The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.

3

Press

C/c to select [YES].

The system outputs the progressive signal.
If you select [NO], the system will not
output the progressive signal.

Note

• [PROGRESSIVE (COMPONENT OUT)] is

effective only when you connect the unit and TV with
a component video cord (page 18).

x [4:3 OUTPUT]

When you use a 16:9 aspect ratio TV, you can
adjust the aspect ratio to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not the
system.

[FULL]: Select this when you can change the
aspect ratio on your TV.
[NORMAL]: Select this when you cannot
change the aspect ratio on your TV. A 16:9
aspect ratio signal with black bands on left and
right sides of the image appears.

Note

• [4:3 OUTPUT] is effective only when you set [TV

TYPE] in [VIDEO SETUP] to [16:9].

Settings for the display

[VIDEO SETUP]

VIDEO SETUP

PROGRESSIVE

(COMPONENT OUT)

:

TV TYPE:

4:3 OUTPUT:

16:9

OFF

FULL

ON

OFF

AUTO

BLACK LEVEL:

PAUSE MODE:

BLACK LEVEL

(COMPONENT OUT)

:

16:9 aspect ratio TV

Advertising