Sony 3-289-204-12(1) - Manual (Page 46)

46 US
D:\SONY HA\3289204121\01US-STRDA2400ESUC\030CON.fm masterpage: Left
STR-DA2400ES
3-289-204-12(1)
The Auto Calibration function allows you to
measure the following:
• Speaker connections
a)
• Speaker polarity
• Speaker distance
a)
• Speaker size
a)
• Speaker level
• Frequency characteristics
a)b)
a)
The measurement result is not utilized in the
following cases.
–The multi channel input is selected.
–“Analog Direct” is being used.
b)
The measurement result is not utilized in the
following cases.
–Dolby TrueHD signals with a sampling
frequency of more than 96 kHz are being
received.
–PCM signals with a sampling frequency of more
than 96 kHz are being received.
1
Press GUI MODE to select “GUI
ON”.
“GUI MODE” appears on the display
window of the receiver and the GUI menu
appears on the TV screen. Press MENU
if the GUI menu does not appear on the
TV screen.
2
Press V/v repeatedly to select
“Settings”, then press or b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
“Auto Calibration”, then press
or b.
4
Press V/v repeatedly to select
“Auto Calibration Start”, then
press
or b.
5
Press to select “START”.
6
The measurement starts in five
seconds.
7
Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Tip
The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
Performing Auto Calibration
CATEGORY
MODE
GUI
MODE SLEEP
NIGHT
MODE RESOLUTION
MUSIC MOVIE
HOME
A.F.D. A.DIRECT
2CH/
INPUT
2-5
1
MENU