Large frame snowthrowers, Easy turn™ cable adjustment – Simplicity Manufacturing L1428E User Manual

Page 16

Advertising
background image

Large Frame Snowthrowers

TP 300-4458-00-LW-SN

07/2007

16

Figure 8. Speed Selector Linkage
A. Speed Selector Rod
B. Jam Nut
C. Ball Joint
D. Locknut
E. Shift Rod

A

8. Loosen the jam nut (B, Figure 8).

9. Remove locknut (D).

10. Move the friction wheel (A, Figure 7) to the correct

distance 4-5/16” (10.95 cm).

11. Turn the ball joint (C, Figure 8) until it is aligned with

the mounting hole in the shifter rod (E). When
aligned, attach the ball joint (C) to the shifter rod (E)
and tighten the jam nut (B) and locknut (D).

12. Check that the snowthrower operates in R1. If not

follow procedures 1-11 and readjust as necessary.

13. Install the bottom panel (B, Figure 6) and tighten the

capscrews (A).

B

C

D

E

EASY TURN™ CABLE ADJUSTMENT

If the Easy Turn™ cable has stretched, the gears will not
disengage when the control lever is activated. Adjust the
cable using the following procedure.

1. Turn the engine off and disconnect the spark plug

wire.

2. Loosen the jam nut (B, Figure 9).

3. Turn the adjustment nut (A) to lengthen or shorten

the cable. The cable should be tightened just until all
slack is removed from the lever, however it must not
engage the Easy Turn™ release without depressing
the control lever.

4. Tighten the jam nut.

A

B

Figure 9. Easy Turn™ Cable Adjustment
A. Adjustment Nut
B. Jam Nut

Advertising
This manual is related to the following products: