Samson Resolv A5 - Manual (Page 7)

1. HIGH FREquENCy LEvEL – Four-position
switch used to adjust the high frequency
response (in 3dB increments).
2. vOLuME - Controls the amount of output level.
3. XLR INPuT (A6 AND A8 ONLy) - Balanced,
+4dBu line level input is connected here via
standard XLR (microphone) cable.
4. POWER SWITCH – Main power switch.
Resolv A Series Layout
Rear Panel Layout - A8a
5. vOLTAGE SWITCH – Used to select the
operating voltage.
NOTE: Be sure to check the voltage setting is
correct for your country. Also, be sure to use the
correct fuse type when changing the voltage.
6. AC INLET - Connect the supplied IEC power
cable here.
7. RCA – Used to connect signals from unbalanced,
–10dBV devices.
8. 1/4-INCH PHONE – Balance TRS (Tip, Ring,
Sleeve) 1/4-inch phone plug used to connect
balanced or unbalanced +4dBu line level signals.
6
8
5