Reverse, Zone dir set/zone area set, Exit – Samsung SCC-C6475P User Manual
Page 53: Set zoom, Zone dir set, Zone area
4-21
E
REVERSE
The REVERSE function applies PRIVACY MASK to the other area than
set as a privacy zone. ON/OFF is available.
ZONE DIR SET/ZONE AREA SET
This function indicates the ID or direction depending on the set value
when PAN of SCC-C6475(P) is located in a specific area. If set to AREA,
it indicates the ID of the selected area and if set to
N(NORTH), NE(NORTH-
EAST), E(EAST), SE(SOUTH-EAST), S(SOUTH), SW(SOUTH-WEST), W(WEST),
NW(NORTH-WEST
.
EXIT
"QUIT" : Does not save the selected information and returns to a higher
menu.
"SAVE" : Do saves the selected information and returns to a higher menu.
"DEL" : Deletes the selected information and restores the DEFAULT.
Then returns to a higher menu.
PRIVACY ZONE SET 0
SET ZONE AREA ON...
SET ZOOM ...
REVERSE ON
EXIT
QUIT
SET ZOOM
Press [ENTER] at the “SET ZOOM...” position to enter the ZOOM setup
screen. After ZOOM setup, the PRIVACY ZONE function will be in action
only at the higher magnification than the Zoom magnification
as set.
➜
Press
[Enter]
SET ZOOM
PRIVACY ZONE SET 0
SET ZONE AREA ON...
SET ZOOM ...
REVERSE OFF
EXIT
QUIT
4-20
ZONE DIR SET
Press the [Enter] key in the “ZONE DIR SET ON…” mode to enter the
NORTH SET screen. MAP. Move PAN to set the NORTH position and
press [ENTER]. Based on the North position,the direction of N(North),
NE(North-East), E(East), SE(South-East), S(South), SW(South-West),
W(West), NW(North-West) is displayed whenever you move PAN.
ZONE AREA
Press [ENTER] to enter the ZONE AREA MAP screen from “ZONE
AREA SET...”. Select a ZONE AREA number from the ZONE AREA MAP
screen and press [ENTER] to enter the ZONE AREA setup screen.
➜
Press
[Enter]
(ZONE AREA MAP)
0 *
1 2 3
4 5 6 7
RET
(ZONE SET)
PRIVACY ZONE
...
ZONE DIR SET
OFF
ZONE AREA SET ON...
EXIT
QUIT
➜
Press
[Enter]
(ZONE SET)
PRIVACY ZONE
...
ZONE DIR SET
ON...
ZONE AREA SET OFF
EXIT
QUIT
SET NORTH
N
ZONE AREA SET 0
LOCATION ...
ZONE ID SET ...
ZONE ENABLE ON
EXIT
QUIT
➜
Press
[Enter]
C
C
C
C
a
a
a
a
u
u
u
u
tt
tt
ii
ii
o
o
o
o
n
n
n
n
ZONE DIR/AREA OSD is not displayed in the network viewer.